Watch Adjustment Guide

Put the watch on, and count how many links need to be removed.

Grab the adjustment tool. This should be located in a little bag inside the watch box. Wind the tool anticlockwise for set up.

Notice on each side of the band, the links look different. The side where the link looks hollow, is the correct side to push the link out with the adjustment tool.

Measure up the band inside the adjustment tool. Push the link through the hollow side until most of the pin is out by turning the tool clockwise.

Notice that the flat head exits the band first.

Pull the remaining of the pin out with your fingers.

Leave the pin in a safe place.

Take out all the links that are needed. We recommend to take out even amounts from each side of the band.

Once all the links are removed, rejoin the links with your fingers and carefully slide the pin in. Ensure that the flat head is the last to enter the links.

This should feel like you are doing STEP 4 backwards.

For the rest of the pin that is sticking out, use the flat surface of the adjustment tool to push it in.

Gently press down and make sure the pin is flush with all the other pins.